I'm running with Yokohama Parada Spec X. Size 255/45/20. Love these tires and can't say enough great things about them. They are directional tread, so you will get great grip in wet conditions. Long tire life too. I've had them for about a year and a half now (close to 18,000 miles on them)...
Redarkx hit the nail right in the head. The clutch pedal is sucked in too far. I did this mod awhile back and ran into the same exact problem. Took off the mod and now my cruise control works perfectly again.
I'm running the same drop but with 255/45/20. No rubbing at all. It's super close though, like about a half inch of space. As long as you don't take your U-turns at blaring speeds, you won't have any problems.
As what the title says, I need help installing my URD Maf Calibrator. Actually to be quite honest, I need someone who has done one before to do it for me. Haha. I'm not that great with electrical work and wiring so I don't trust myself at all with installing this alone. Especially when it...
Hey guys. I'm super pumped that I got my intake manifold spacer in the mail today but it didn't come with any instructions on how to install it. I found another post on here that shows how to install it on a supercharged engine but I am running without one. I don't know if the install is any...
I am putting on some DT headers today and decided to throw on a new set of gaskets as well. You can have my used stock gaskets if you'd like. They have about 70,000 miles on them but no leaks. Let me know if you're still interested.
Any of you wheel and tire gurus out there please chime in and help me out. I am currently running on 20x8.5 rims with a +34mm offset. The front of my X is stock height and the rear is dropped 1.5''. I am stuck on deciding between three different sizes of tire right now: 245/45/20, 255/40/20...
Hey guys. Maybe some CA peeps can chime in and help me out with this. I already have Thorley short tube headers installed and am looking to install some rear high flow cats on my X. Only question is will I pass smog? I know I will pass the visual inspection but I am not so sure about the part...
Count me in
As a Canadian living way down in Los Angeles, I would love to have one of these. Let's make it happen Coupe. Good idea.
7. wlylwinstin182, Red, weighted, engraving under the shift pattern "NPS2083" (the 0 is a zero).
Christ - I haven't personally checked the shoes yet but I still have the stock shoes on from when the car was first produced. Point being...the shoes have about 60,000 miles on them. Starting to make noticeable noise. I will also be doing a complete fluid flush as well.
Rich - Thanks for the...
I have finally decided to redo the entire braking system on my X. I would love a BBK but can't afford it at the moment. So I will be ordering parts from brakeperformance.com and other sites. I have decided to get the premium dimple-drilled and slotted rotors with some TRD pads and Stoptech SS...
Hey guys. I am currently running a TRD CAI, DT short tube headers, Spintech high flow cat converters, and a Spintech super prostreet muffler setup. Questions...
- Would the URD MAF calibrator still work with this setup even though I am not using any URD parts?
- Would the URD MAF calibrator...