Recent content by Detective_Dan

  1. Detective_Dan

    Detective_Dan's Build Round 3

    Hahahaha **** you lol
  2. Detective_Dan

    sad day removing mods on the X

    Gonna take a shot in the dark here, but were you on holloman afb recently? I saw a blacked out x that looks lie yours and was just curious lol
  3. Detective_Dan

    Detective_Dan's Build Round 3

    Yea it's a bastard to keep clean, but at the same time , I bought it for exploring so she looks good covered in mud lol
  4. Detective_Dan

    Detective_Dan's Build Round 3

    already had some fun with her, still with dealer tags lol rear tire about 8" off the ground
  5. Detective_Dan

    Detective_Dan's Build Round 3

    welp, im on build #4 now lmao. i hated not being in a truck so i picked up a 2014 4x4
  6. Detective_Dan

    Biggest Rear tire?

    I had 315/35/20 nitto nt05's on mine. Fit very nicely
  7. Detective_Dan

    Detective_Dan's Build Round 3

    Depends on how the ride is after I decide what drop I want
  8. Detective_Dan

    Detective_Dan's Build Round 3

    No worries. Yes they are carbon fiber. I wanted all black but the carbon was all I could find. It replaces the fog lights and opens up the trans cooler and oil cooler much much more
  9. Detective_Dan

    Detective_Dan's Build Round 3

    We don't have a front plate. I just set it there for the pic. Technically the my evo was a Texas car and required a front plate from the original owner. If I had to mount one up front, I have a bracket that goes where those 3 black plugs are at on the front drivers side bumper. And yes if I...
  10. Detective_Dan

    Detective_Dan's Build Round 3

    got my new license plate in today, I just set it in the grill for the pic. mount location is on the rear
  11. Detective_Dan

    Detective_Dan's Build Round 3

    Lol. Consistent 14.1's but I didn't launch against the ms3, that run was a 14.4. Once I get it tuned, it will be low 13's because it will remove the first gear limiter, letting it launch much harder
  12. Detective_Dan

    Detective_Dan's Build Round 3

    both of these videos were just before i installed the exhaust, so, its a stock evo. (please excuse my cameraman yelling "VTEC!!!" it was an inside joke and had us laughing all night) http://www.youtube.com/watch?v=WlBXLYNsq2Q http://www.youtube.com/watch?v=ouKErRiWP4s
  13. Detective_Dan

    Detective_Dan's Build Round 3

    Yet it is. Front measures 2.3 and rear measures 1.6. The springs I'm looking at should drop it almost evenly, and give about .5" wheel gap on all 4 corners
  14. Detective_Dan

    Detective_Dan's Build Round 3

    Lol yea. The wheel gap honestly doesn't bother me, it would just look so much better dropped hahaa
Top