Search results
-
Left Overs
x-1 has the stock gears out of the truck. They can be drilled to work per Gadget. The wheels were on my truck for 10k miles, so ya they fit :) -
Left Overs
Traded the X and I have some parts left over. URD TCAI (black) with blue filter, injen shield $150 (no MAF sim) X-1 in the original box w/ stock gears and no t-stat $800 Scosche single and double din install kits new $20 each shipped Stock headlight units 500 miles $80 shipped Enkei... -
Blowing cold air, the dealership and mods
OK. I removed the x-1 and resoldered the O2 sim back in again and still have 1 sensor fault, so I'll get that replaced. On the way to work today i got pissed and started cranking the heat dial from cold to hot. I was rewarded with a repeating clunking sound and actually got warm air instead of...- Kolt45
- Post #19
- Forum: N/A Mods & Tuning
-
Blowing cold air, the dealership and mods
Ah crap now im worried. At this point, should I pull headers back to stock, pull the o2 sim and let the dealership (different town) worry about it? How could both O2' s go at the same time? I only have 30k on this truck, and the dealership is telling me to f off. I see a part out in my future if...- Kolt45
- Post #15
- Forum: N/A Mods & Tuning
-
Blowing cold air, the dealership and mods
my bad, P0051 and P0158...02 sensor high voltage...hmm i just soldered the o2 sim back in after removing the x-1 :(- Kolt45
- Post #12
- Forum: N/A Mods & Tuning
-
Blowing cold air, the dealership and mods
code 3 codes going on. p2197,p0051,p0058- Kolt45
- Post #9
- Forum: N/A Mods & Tuning
-
Blowing cold air, the dealership and mods
Ok, fans work fine. MAF and O2 sim wiring checked and good when i removed the X-1. Not sure how to check the door for the hot/cold blender but i am getting flow thru vents. Also noticed when i sit and let idle for 20 minutes or so, i am getting warm (not hot) air for a few seconds before going...- Kolt45
- Post #6
- Forum: N/A Mods & Tuning
-
Blowing cold air, the dealership and mods
So my X is blowing cold air and I want to see if any of this makes sense. I was on the home the other day, and the heater went from hot to cold air. Didnt touch anything, just click. CEL comes on. The truck has been occasionally sputtering on acceleration and on maintained RPM in the 3k range...- Kolt45
- Thread
- Replies: 26
- Forum: N/A Mods & Tuning
-
Enkei 18" LS-5
Enkei LS-5's. About 10k on them, no rash or dings. Includes Red stars, can be painted to match. Cleaning shop, so $500 SHIPPED to lower 48. Also open to trades, will consider anything of value (I am an FFL dealer so will consider firearms as well). -Kolt -
Sick X this morning
I think I found the problem. A vacuum hose on top of the intake was pulled loose. reattached and fired right up, no CEL. No problems on morning drive. I hope that was all it was, almost seems too simple.- Kolt45
- Post #8
- Forum: N/A Mods & Tuning
-
Sick X this morning
abosulty nothing new. All this has been since my last fuel stop, standard fill'r up with super. I'll check the basics tonight when I get home. Still have to figure out which code is thrown (first time a CEL has come up)- Kolt45
- Post #4
- Forum: N/A Mods & Tuning
-
Sick X this morning
So I went to go to work today, jumped in and tried to start up. Caught normal then instantly died...hmmm wierd. Keyed off and on, x-1 blinks good, started but CEL is on. Did a quick walk around, exhaust smells like fuel and my exhaust tip is BLACK. Double wierd. I did notice yesterday on the way...- Kolt45
- Thread
- Replies: 7
- Forum: N/A Mods & Tuning
-
Roadtrip Help Oregon Peeps
101 ihas almost never snow or ice, no passes, but WAY slow and twisty. I-5 has Grants pass (which SUCKS in snow), small pass between Roseburg and Eugene, then your clear to Portland. Depending on the storms, it can be really bad driving. We can have upto 2-4"+ of snow in the hills, with IDIOT...- Kolt45
- Post #4
- Forum: Pacific Northwest
-
Enkei LS-5 Wheels 18"
I belive they are +40 if i remember right. I'll double check in the morning -
-
Enkei LS-5 Wheels 18"
Up for grabs are my 18x8" Enkei LS-5's with red inserts. 10k on the them, NO rash or uglies, still got the original boxes. $650 shipped to the lower 48. -
Is it worth it!?
dont even get me started on cash for gold!!!!!! I'm so pissed I didnt think of that first!- Kolt45
- Post #31
- Forum: Polls & Surveys
-
Is it worth it!?
I've been in the retail jewelry and owned a pawn shop for 10 years. The problem with reselling a ring like that is our intial markup. I dont care what jeweler you go to be it Kays or Fred Meyer, we mark up retail 1000%. Yes, you heard right we add a zero. So the ring that is 3k, we paid...- Kolt45
- Post #26
- Forum: Polls & Surveys
-
Sittin Sic with new Varrstoen's Time Attacks
255/40 in front and 285/35 in the rear- Kolt45
- Post #19
- Forum: Aftermarket Wheels/Tires
-
Sittin Sic with new Varrstoen's Time Attacks
Right on, ya thats my pawn shop where I park. Pop in and say hi sometime! -Kolt- Kolt45
- Post #4
- Forum: Aftermarket Wheels/Tires
