3" Angled Blocks W/U-bolts..etc

[xtoplinex]

Yeah I'm looking for some, would any of you guys happen to be selling any?..or if anything,is there a link I can buy 3" blocks from (DJM preferably). Thanks.:top:

 

[Stevenredx]

Have you tried DJM directly?? i know they sell them separately :top:

 

[xtoplinex]

Have you tried DJM directly?? i know they sell them separately :top:

I know...but I wanted to c if someone could sell it for cheaper or something.:dontknow:

 

[LEX-RUNNER]

off the subject a lil', Just curious if it was o.k. 2 run a 3" block in the rear. dont know if there would be any problems with pinion angle?looking at the kit from I think it was c2c, but wanted to go with a 3" block in the back. any feeed back would be great!!
~Thanx!

 

[Matt's06]

off the subject a lil', Just curious if it was o.k. 2 run a 3" block in the rear. dont know if there would be any problems with pinion angle?looking at the kit from I think it was c2c, but wanted to go with a 3" block in the back. any feeed back would be great!!
~Thanx!

Pinion angle is not a problem. You have to cut your frame and put a mini c-notch in.

 

[x-runner kid]

hey this is where I found all my djm stuff and they don't have the notch unless you write them and ask them about it then they will send you the link for it thats what I did.http://truckshop.com/catalog/Toyota-p-1-c-455.html